Allow test, urine specimen, and/or controls to reach room
temperature (15-30°C) prior to testing.
1. Bring the pouch to room temperature before opening it. Remove
the test cassette from the sealed pouch and use it within one hour.
2. Place the test device on a clean and level surface. Hold the
dropper vertically and transfer 3 full drops of urine (approx.
120μL) to the specimen well (S) of the test cassette, and then
start the timer. Avoid trapping air bubbles in the specimen well
(S). See the illustration below.
3. Wait for the colored line(s) to appear. Read results at 5
minutes. Do not interpret the result after 10 minutes.
【DIRECTIONS FOR PANEL USE】
Allow test, urine specimen, and/or controls to reach room
temperature (15-30°C) prior to testing.
1. Bring the pouch to room temperature before opening it. Remove
the test panel from the sealed pouch and use it within one hour.
2. Remove the cap.
3. With the arrow pointing toward the urine specimen, immerse the
test panel vertically in the urine specimen for at least 10 to 15
seconds. Immerse the strip to at least the level of the wavy lines,
but not above the arrow on the test panel.
4. Replace the cap and place the test panel on a non-absorbent flat
surface.
5. Start the timer and wait for the colored line(s) to appear.
DIRECTIONS FOR DIPSTICK USE
Allow test, urine specimen, and/or controls to reach room
temperature (15-30°C) prior to testing.
1. Bring the pouch or closed canister to room temperature before
opening it. Remove the Test Dipstick from the sealed pouch and use
it within one hour.
2. With arrows pointing toward the urine specimen, immerse the Test
Dipstick vertically in the urine specimen for at least 10-15
seconds. Do not pass the maximum line (MAX) on the Test Dipstick
when immersing the strip. See the illustration below.
3. Place the test dipstick on a non-absorbent flat surface, start
the timer and wait for the colored line(s) to appear. Read results
at 5 minutes. Do not interpret the result after 10 minutes.
INTERPRETATION OF RESULTS
(Please refer to the illustration above)
NEGATIVE:* Two lines appear. One color line should be in the control region
(C), and another apparent color line should be in the test region
(T). This negative result indicates that the Fluoxe/tine (FLX)
concentration is below the detectable cutoff level.
*NOTE: The shade of color in the test region (T) may vary, but it should
be considered negative whenever there is even a faint color line.
POSITIVE: One color line appears in the control region (C). No line appears
in the test region (T). This positive result indicates that the
Flu/oxetine (FLX) concentration is above the detectable cutoff
level.
INVALID: Control line fails to appear. Insufficient specimen volume or
incorrect procedural techniques are the most likely reasons for
control line failure. Review the procedure and repeat the test with
a new test Dipstick. If the problem persists, discontinue using the
test Dipstick immediately and contact your local distributor.
Order Information
| Cat. No. | Product | Specimen | Pack |
| DFLX-102 | Fluox/etine (FLX) Rapid Test Cassette | Urine | 40T |
| DFLX-114 | Fluox/etine (FLX) Rapid Test Panel | Urine | 40 T |
| DFLX-101 | Fluox/etine (FLX) Rapid Test Dipstick | Urine | 50 T |
